Sony G363-ZR0-LAX1 User Manual page 433

• During the course of a transition, there is a "dead zone" corresponding to the
Keyframe effect
A
First keyframe
Mid-point of effect
• Create the last keyframe for each channel as follows.
• In the <Transition Mode> group of the Key Frame >DME User PGM menu,
432
Creating User Programmable DME Patterns
Note
It is recommended to make the priority settings at a keyframe point at which
the two images are not overlapping.
intermediate point of the whole effect (see following figure), during which
the image does not change. Therefore, it is necessary to create the effect so
that the image in the intermediate part of the transition is the keyframe for
the mid-point of the whole effect. The range of this "dead zone" corresponds
to the central one-third of the range of the transition indicator. This also
applies to an auto transition.
B C
Last keyframe
Channel 1: since the priority is low, it will not be visible on the screen, so
no particular restrictions apply.
Channel 2: create the image full-size.
select [P In P].
Change in image through transition
Image at point C
appears
Image at point B
appears
(dead zone)
Image at point A
appears
Transition indicator
Fader lever