• Xpt Hold mode: Set the operation mode for the cross-point hold button
• Pattern Limit Transition: Set the operation mode when the pattern limit is
• Wipe Edge Default: Adjust the wipe edge softness for each of the M/E and
• FM Auto Store: Switch on or off the function to automatically attach a name
Link settings (Link)
• Internal Bus Link: Make a setting of the bus link function that links
• GPI Link: Make settings for linking any cross-point buttons or [CUT] and
• M/E Link: Make settings to link together two M/E banks.
• Key Trans Link: Make settings to link key transitions.
External device connections (Device Interface)
• Remote Assign: Set the use of the four 9-pin ports.
• GPI Input: Set the GPI input ports and trigger polarities, and make the
• GPI Output: Set the GPI output ports and trigger polarities, and make the
• Aux Control: Set whether operations on the AUX buses from the four 9-pin
• DME Type Setting: When the DME is an MVE-9000 or MVE-8000A, carry
DME Setup
In DME setup, carry out settings particular to the DME processor.
You can make the following settings.
Input signal settings (Input)
• Initial Crop: Make the initial crop setting.
• Matte Illeg. Color Limit: Switch the illegal limiter for the signal generated
• System Phase: Adjust the operation timing of the whole system with respect
• TBC Center: Set the TBC window center position.
182
Setup
provided on the key bus for each of the M/E and P/P banks.
released for each of the M/E and P/P banks.
P/P banks.
and save in frame memory.
together two buses internal to the switcher.
[AUTO TRANS] buttons in the cross-point control block and GPI output
ports.
action settings.
action settings.
ports are inhibited.
out interface settings, and for an SDI interface set the AUX bus outputs and
reentry inputs.
by the DME internal matte generator on or off.
to the reference signal.