Table of Contents
Advertisement
4
When using the SDI interface
The operations to select the video signals for the third and fourth channels
differ from those in the previous procedure: select the video signals on the
AUX bus allocated in a Setup menu (Engineering Setup >Switcher >Device
Interface >DME Type Setting >DME SDI Interface menu).
Note
In setup (Engineering Setup >Switcher >Device Interface menu), if "Up to
3Keys" is selected, the second channel video signal is also selected on the AUX
bus.
For details, see "Interfacing With External Devices (Device Interface Menu)"
in Chapter 16 (Volume 2).
You can check the DME operating status in the Status menu (see page 490).
Assigning a DME output signal as a monitor signal
1
2
3
362
Key Setting Operations Using Menus
To select the video signal for the fourth channel, hold down the [UTIL]
button in the cross-point control block, and carry out the following
operation.
• If the selected DME is channel 4, turn on the [KEY4] button in the key
2 row, then select the signal in the key 4 row (DME utility 2 bus).
• If the selected DME is channel 8, turn off the [KEY4] button in the key
2 row, then select the signal in the key 2 row (DME utility 1 bus).
In the Processed Key menu, press [Monitor].
The Monitor menu appears.
Press [Monitor Set], turning it on.
In the <DME Select> group, select the DME channel (DME1 to DME8) to
be used.
This assigns the selected DME output to DME MON V and DME MON K.
The colors with which [DME1] to [DME8] are lit show the key assignment
status.
Lit green: DME currently being monitored
Lit amber: DME that can be monitored
Off: Unassigned DME
Advertisement
Table of Contents
