Sony G363-ZR0-LAX1 User Manual page 387

Selecting a wipe pattern in the Flexi Pad control block
To select a pattern with a standard type Flexi Pad control block, use the
following procedure. (It is not possible to select a wipe pattern with a simple
type Flexi Pad control block.)
1
2
386
Basic Procedure for Wipe Settings
Knob Parameter Adjustment
2 V Size Tile height
3 Volatility Rate of tile generation
• When a diamond dust wipe is selected (pattern number 274)
Knob Parameter Adjustment
1 H Size Particle width
2 V Size Particle height
3 Flash Rate Rate of generation of particles
Note
When Flash Rate is set to 0.00, you cannot change the pattern. In this state,
adjusting H Size or V Size has no effect on the pattern.
For details of a pattern mix, see the next section.
For details of applying pattern modifiers, see "Setting Wipe Modifiers"
(page 389).
In the M/E-1 Flexi Pad control block, press the [WIPE] button.
This switches the Flexi Pad control block to wipe snapshot mode.
In the memory recall section, press the [PTN NO] button.
Setting values
0.00 to 100.00
0.00 to 100.00
Setting values
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00