• The necessary settings have been made in a Setup menu to enable the split
• A background is selected for the next transition.
• For the transition type, [MIX] or [NAM] is selected.
Split fader operation
The two halves of the split fader lever correspond to the buses as follows.
Right fader lever: Background A bus
Left fader lever: Background B bus
The relationship between the positions of the two fader levers and the image
output in a mix is as follows.
Left lever position Right lever
Top
Bottom
Top
Bottom
Center
• When the transition type is NAM, the outputs of the A bus and B bus in the
• The transition indicators always show the progress of the background A bus.
• The operation of the left lever and that of the right lever can be swapped. (See
Independent Key Transitions With a Simple Transition
Module
You carry out independent key transition operations using the independent key
transition control block (simple type). This controls only keys 3 and 4.
However, each key button can be assigned to any key in setup (see Chapter 16
"Overall Control Panel Settings (Config Menu)" (Volume 2)).
334
Simple Transition
fader (See "Settings Relating to Video Switching (Transition Menu)" in
Chapter 16 (Volume 2).)
position
Top
Top
Bottom
Bottom
Center
above table are the outputs subjected to NAM.
"Operation Settings (Operation Menu)" in Chapter 16 (Volume 2).)
A bus output
B bus output
100%
0%
100%
100%
0%
0%
0%
100%
50%
50%