Table of Contents
Advertisement
Transition Control Block and Flexi Pad Control Block (with INH
button)
LIMIT
SET
PIN
LIMIT
NORM
/REV
REV
TAKE
a Transition type selection buttons
You can assign these buttons in setup to any
transition type (see "Overall Control Panel
Settings (Config Menu)" in Chapter 16
(Volume 2)). Press any of the following
buttons, turning it on, to select the transition
type.
Press one of these buttons, turning it on, to
determine the type of the next transition for
a background.
To select the key transition type, hold down
the [KEY1] or [KEY2] button, and press
one of the following buttons, turning it on.
When multi-program mode is selected in
the Setup menu (see "Settings for Switcher
Configuration (Config Menu)" in Chapter
16 (Volume 2)), two or more of the
following buttons may light.
MIX: In a background transition, the new
video fades in as the current video
MIX
NAM
WIPE
DME
Names and Functions of Parts of the Control Panel
qs INH button
XPT HOLD
A B U
U
1 2 3 4
1
2
INH
WIPE
DME
SNAP
SHOT
UNDO
Memory recall section
UNDO button
fades out. During the transition, the
overall signal level is maintained at
100%.
In a key transition, the key fades in (for
insertion) or out (for removal).
NAM (non-additive mix): The current and
new video signals are compared, and
the signal with the higher luminance
level is given priority in the output.
The current video is maintained at
100% output for the first half of the
transition as the new video increases
progressively to 100%, then the current
video is progressively reduced from
100% to zero in the second half while
the new video is maintained at 100%.
WIPE: The current video is replaced by the
new video, using the wipe pattern
selected in the Wipe menu.
261
Advertisement
Table of Contents
