Table of Contents
Advertisement
– "Type + Num" name set on routing switcher
Names assigned with Xpt Assign can be replaced later with description
names.
• Name Display: Specify the number of characters for display of the names
selected in Source/Dest Name above, as two characters, four characters, or
Auto.
• Flexi Pad: Carry out Flexi Pad settings. Specify the delegation selection
coupling, and display mode for the LCD buttons. You can also make menu
settings for wipe snapshots.
• Custom Button: Set the following button operation modes.
– [ALL] button for next transition selection
– [AUTO TRANS], [TAKE] or [FTB] button during auto transition
execution
– [RUN] button during keyframe execution
– [AUTO TRANS] and [CUT] button replacement
– [TRANS PVW] button
– [UTIL] button
– [XPT HOLD] button in key rows
– Selection of signal assigned to the auxiliary bus control block key source
bus (either key signal only, or either video signal or key signal selectable)
• Sensitivity: Adjust trackball, joystick and double-click sensitivity, or set the
relationship between the angle of the search dial and the playback speed.
• Main Split Fader: When the split fader is active, specify whether the fader
to control other than mix is the left side or the right side.
• Macro: Set the macro execution mode and the mode in which to edit macros
using the standard type Flexi Pad control block.
Screen saver and other settings (Maintenance)
• Screen Saver: Make the menu screen saver settings.
• LCD Brightness: Adjust the LCD brightness.
• LED Brightness: Adjust the LED brightness.
• Switch Brightness: Adjust the switch brightness.
• Touch Beep: Select whether or not to sound a beep when a menu operation
is carried out.
• Touch Panel Calibration: Calibrate the touch panel.
• Initial Menu Set: Specify the menu to be displayed at menu startup.
Switcher Setup
In switcher setup, make settings particular to the switcher processor.
You can make the following settings.
179
Setup
Advertisement
Table of Contents
