Sony Tektronix VX4792 User Manual page 236

Prerequisites
Equipment Required
Table F-1: Test Equipment Requirements
Item Description
Oscilloscope
Function Generator
Frequency Counter
Digital Multimeter (DMM)
TM 5000 Series Power Module
VXIbus Mainframe
VXIbus Resource Manager
Personal Computer
1
Four channels are recommended when performing the Synchronous Operation Checks.
2
Requires a TM 5000 Series Power Module.
VX4792 User Manual
The tests in this section comprise an extensive, valid confirmation of perfor-
mance and functionality, when the following requirements are met:
H The waveform generator must be operating as an integral part of an
appropriately configured mainframe
H The operating conditions must comply with those specified for the system
mainframe in which the waveform generator is installed
H The test environment must comply with the limits described in Table E–2
Environmental Characteristics
H The waveform generator must have been calibrated at an ambient tempera-
ture between +20_ C to +30_ C following a 20 minute warm up period
H The waveform generator must be operating for at least 20 minutes before the
tests are performed
The performance verification procedures have been written using the test
equipment listed in Table F–1. If alternate equipment is used, the equipment
must meet or exceed the minimum requirements shown in Table F–1.
Minimum Requirements
Bandwidth: 350 MHz
1
Two channels
Output voltage: -5 V to +5 V
Frequency range: 10 Hz to 250 MHz
Accuracy: ±10 ppm
DC volts range: 0.05 V to +5 V
Accuracy: ±0.1%
6 plug in slots
C size
C size slot 0 resource manager
IBM PC/AT compatible
Performance Verification
Recommended Instrument
Tektronix TDS500 Series Digitizing
Oscilloscope or 2400 Series Digitizing
Oscilloscope
Tektronix FG 5010 Programmable Function
2
Generator
Tektronix DC 5010 Programmable Univer
2
sal Counter/Timer
Fluke 8842A
Tektronix TM 5006A Power Module
Tektronix VX1410
Tektronix VX4521
IBM PC, PC XT, PC AT, or PC compatible
computer
F-3