Summary Of Procedures; Equipment Required; Table 6-4: Equipment Required - Sony Tektronix AWG2021 Service Manual

Removal and Installation Procedures

Summary of Procedures

Equipment Required

6-10
The Access Procedure on page 6–12 identifies the procedure for removing each
module. These categories separate the procedures based on their location in the
AWG2021.
H Procedures for External Modules on page 6–15 describes how to remove
modules which can be removed without internal access to the AWG2021.
H Procedures for Internal Modules on page 6–26 describes how to remove
modules which require internal access to the AWG2021.
The removal of most modules in the AWG2021 requires only a screwdriver
handle mounted with a size T-15, TorxR screwdriver tip. Use this tool whenever
a procedure step instructs you to remove or install a screw, unless a different size
screwdriver is specified in that step. The first step of a module procedure lists all
equipment required to remove and reinstall the module.

Table 6-4: Equipment Required

Name
Screwdriver handle
T 9 TorxR tip
T 10 TorxR tip
T 15 TorxR tip
#1 Phillips tip
Flat bladed screwdriver
Hex wrench, 0.050 inch
1
Hex wrench, / inch
16
Needle nose pliers
1
Nut driver, / inch
2
1
Nut driver, / inch
4
5
Nut driver, / inch
16
Nut driver, 5 mm
1
Open end wrench / inch
2
Soldering iron
Description
Accepts TorxR driver bits
TorxR driver bit for T 9 size screw heads
TorxR driver bit for T 10 size screw heads
TorxR driver bit for T 15 size screw heads
Phillips driver bit for #1 size screw heads
Screwdriver for removing standard headed
screws
Standard tool
Standard tool
Standard tool
Standard tool
Standard tool
Standard tool
Standard tool
Standard tool
Standard tool
Part Number
003 0524 00
003 0965 00
003 0815 00
003 0966 00
003 0335 00
AWG2021 Service Manual