Table of Contents
Advertisement
3.
Set the end position (the black square mark on the rectangle) of the circle.
Move and position the start point by tilting the ENTER key in the desired direction. Press the C key to go
back to the previous step.
Drawing a Circle
Follow the steps below to set the start and end points of the circumscribing rectangle after displaying a checker
shape on the screen by selecting "Change". If you want to draw a circle or an ellipse with the Flaw Detection
function, refer to section 6.11, "Flaw Detection" on page 129.
1.
Move the whole circle.
Move the whole circle by tilting the ENTER key in the desired direction
and press the ENTER key to fix the position.
2.
Fix the start point (the white square mark on the circumscribing rectangle).
Move the circumscribing rectangle by tilting the ENTER key in the
desired direction and press the ENTER key to fix the position. Press the
C key before pressing the ENTER key to go back to the previous step.
3.
Set the end position (the black square mark on the circumscribing rectangle) of the circle.
Move the end point by tilting the ENTER key in the desired direction and
press the ENTER key to fix the position. Press the C key before
pressing the ENTER key goes back to the previous step.
50
Advertisement
Table of Contents
