Table of Contents
Advertisement
Forced Outage (Pause of Inspection)
PV310 keeps the READY signal turned off and does not accept signals from the external devices.
When "Output operation" is set to "Synchronous", you can select whether output the image that is failed to output
or not. Operating the keypad following the displayed messages turns on the READY signal and makes PV310 be
ready for the next inspection.
To restart inspections, input start signals again, even if the inspects repeatedly ("Start" is set to "Repeat").
Output
Message
operation
Asynchronous
"Image output error through Ethernet
occurred. Please verify the connection."
Synchronous
"Image output error through Ethernet
occurred. Please verify the connection.
Do you want to retransmit the latest
captured image?"
Procedure
1.
Select [ENVIRONMENT] → [Image Output Settings] → [Output settings] from the menu bar.
2.
Configure [Output signal (ERR) at error], [Forced outage at error] to meet your need.
Operation
None
Output error signal
Forced outage
Output error signal
＋
Forced outage
238
[Output signal (ERR)
Forced outage at error
at error]
OFF
OFF
ON
OFF
OFF
ON
ON
ON
Keypad Operation
Select [OK].
•
To not retransmit the image
Select [NO].
•
To retransmit the image
1.
Select [YES].
The message saying "Transmission was
completed." shows when the image
retransmission was completed correctly.
2.
After retransmission, select [OK].
* If the retransmission failed, the left message
appears again.
Advertisement
Table of Contents
