Table of Contents
Advertisement
STAGE Screen
(4) Light the preceding (-1) channel. The channel immediately before the LAST operation goes
out.
The level of lighting remains unchanged from that specified before.
> LAST
3)
Changing the channel display mode
* If the CC comment display mode is entered by pressing F13 (DspMod) and then the [@] operation is
performed, the level display mode is entered automatically. In this case, the CC comment display
mode is resumed when the command line is cleared.
Each time the F14 (DspMod) button is pressed, the display mode switches as shown below:
Level → CH comment → CC comment → Level
4)
Switching of the display of NEXT-CUE level data
* Tracking is recorded in CUE number order. If the NEXT-CUE number goes out of the order during
playback operation, it is displayed at the bottom of the screen.
Each time the F15 (NXTODR) button is pressed, the display of NEXT-CUE data is switched to NEXT
NUM ORDER or NEXT PLY ORDER.
5)
Inheriting the temporary edit level
When the next CUE is executed during @ or @COLOR operation with a specified channel level (the
level displayed in a pink tile color), the channel with the specified channel level is forcibly output.
The channel is forcibly output even when the next CUE is not at the inherited level (displayed in light
blue). If the specified channel level is canceled (or a screen other than STAGE is displayed, or the
command line is cleared), normal control is resumed at the next CUE playback.
When the next CUE is executed, the temporarily edited channel (the level is displayed in yellow), not the
specified channel level (displayed in pink tile color), is played back at the level recorded before the edit
operation.
13-3
Advertisement
Table of Contents
