Adding A Comment To A Macro - Toshiba LICSTAR-IV SE Instruction Manual

MACRO Screen
2) Switching the function displays
Each time the F12 (SHIFT) button on the SETUP keyboard is pressed, F1 to F10 switches to F11 to
F20 and back again.
(F1 - F10)
F1 START 2 REC 3
(F11 - F20)
# MC-P # #
3) Recording buttons pressed on the panel to a MACRO button
* While a macro is being recorded, the buttons on the LIGTING CONTROL CONSOLE do not work
as usual. Therefore, be sure to end of macro recording when it is not needed.
* M1 to M10 are displayed below the function keys on the SETTING screen.
M11 to M20 are displayed below the function keys on the SETUP screen.
To record a macro, click the desired MACRO button.
Press the F1 (START) button. The message KEY INPUT BEING RECEIVED is displayed at the
upper right of the screen.
Pressing the F1 (START) button again cancels this message.
Example) Record @75 on the M1 button.
> Click M1 (MACRO button on the screen) @ 7 5 F2 (REC)
Example) Record the GO button to the M20 button.
> Click M20 (MACRO button on the screen) GO F2 (REC)
4) Resetting the macro recorded on a MACRO button individually
Press the F1 (START) button. The message KEY INPUT BEING RECEIVED is displayed at the
upper right of the screen.
Each time the BS button is pressed, one of the recorded MACRO buttons are deleted.
> Click a MACRO button on the screen BS F2 (REC)
5) Adding a comment to a MACRO button
> F3 (MACRO) = Comment (single-width or double-width characters) ↵ ↵
Example) Add the comment GO (backup) to the M10 button.
> F3(MACRO) 1 0 = GO(backup) ↵ ↵
MACRO 4 COMENT 5
# #
6 7 ALLCLR
# #
29-2
8 RESET 9 CL #
# < Page # Page > #
MENU
MENU