Toshiba LICSTAR-IV SE Instruction Manual page 87

BLIND Screen
23) Changing the channel display format
* You can select the display format between vertical and horizontal on the DEFAULT screen.
* The display format is kept even after the screen is switched.
23.1) Switching the display format among vertical, horizontal, and free
Each time the F11 (CHlay) button is pressed, the display mode switches as shown below:
Vertical → Horizontal → Display mode set on the CH LAYOUT screen → Horizontal
23.2) Switching between 1-line display and 3-line display
Each time the F12 (1/3) button is pressed, the display mode switches between 1-line display and 3-line
display.
23.3) Switching the display mode between all-CH display and batch-CH display
Each time the F13 (ALL/PT) button is pressed, the display mode switches between all-channel display
and batch-channel display.
23.4) Switching the CH display contents
* f the CC comment display mode is entered by pressing F14 (DspMod) and then the [@] operation is
performed, the level display mode is entered automatically. In this case, the CC comment display mode
is resumed when the command line is cleared.
Each time F14 (DspMod) button is pressed, the display mode switches as shown below:
Level → CH comment → CC comment → Level
Display example) Horizontal 1-line (1-CUE) display mode
11-21