Table of Contents
Advertisement
BLIND Screen
12) Assigning CH(s) to PART(s)
After assignment, part numbers are displayed beside the channel levels on the screen.
12.1)
Assign CH(s) to PART(s). CH levels are not recorded in this operation.
> PART
PART number
Example) Assign CH5 to PART1.
> PART
1
12.2)
Set the levels of CH(s) and assign them to PART(s).
CH levels are not recorded in this operation.
> CH number
Example) Set the level of CH5 to 20% and assign the CH to PART1.
> 5
@
2
13) Raising or lowering the level of CH(s) by 1 or 10
13.1) Changing the levels linearly
> CH number
> CH number
> CH number
> CH number
Example) Lower the level of CH1 by 10.
> 1
@
-10
↑
The COMMAND line on the screen displays the level at the time after @.
13. 2) Changing the levels geometrically
> CH number
> CH number
> CH number
> CH number
Example) Lower the level of CH1 by 10% geometrically.
> 1
%
-10
The COMMAND line on the screen displays the level at the time after %.
13.3)
Raise or lower the level of CH(s) using the SETTING level wheel.
Changing the level(s) linearly
Rotate the level wheel upward to raise the level of the specified CH on the screen.
Rotate the level wheel downward to lower the level of the specified CH on the screen.
Example) Raise or lower the level of CH1 linearly using the level wheel.
> 1
@ Level wheel
=
CH number
↵
↵
= CH 5
@
Level
=
PART
0
=
PART
1
@
+10
Raise the level of the CH specified on the screen by 10 .
@
-10
Lower the level of the CH specified on the screen by 10.
@
+1
Raise the level of the CH specified on the screen by 1.
@
-1
Lower the level of the CH specified on the screen by 1.
%
+10
Raise the level of the CH specified on the screen by 10%.
%
-10
Lower the level of the CH specified on the screen by 10%.
%
+1
Raise the level of the CH specified on the screen by 1%.
%
-1
Lower the level of the CH specified on the screen by 1%.
↑
↑
The COMMAND line on the screen displays the level at the time after @.
↵
↵
↵
PART number
↵
↵
11-8
↵
Advertisement
Table of Contents
