Table of Contents
Advertisement
EFFECT PANEL
3.2) Adjusting the speed from the submaster
Operating procedure
(1) Press the EDIT button above the submaster fader to enter edit mode.
The EDIT button above the submaster fader flashes and the effect assigned to
this submaster is called to the EFFECT PANEL.
After this point the operation should be performed on the EFFECT PANEL.
The EDIT button on the EFFECT PANEL also flashes.
Press the EDIT button again to end edit mode. At this time, all the indicators on the
EFFECT PANEL go out.
(2) Turn the SPEED wheel.
Adjust the speed of the pattern now being played on the EFFECT PANEL.
(3) Press the REC button.
The EDIT button goes out, and all the indicators on the EFFECT PANEL go out.
The current speed is recorded.
Notes
• Because the effect will not be executed unless the submaster fader is raised from 0%,
its speed cannot be adjusted.
5-4
Advertisement
Table of Contents
