Table of Contents
Advertisement
BLIND Screen
10.6)
Specify the CH preceding the currently specified one.
> LAST
Example) Set the levels of CH3 to CH5 to 100% and then specify CH2.
> 3
~
5
LAST
The COMMAND line is displayed as follows:
> 2 @ 5 3
↑
This level is the one set to CH6 on the BLIND screen.
10.7)
Restore the channel at the immediately preceding level to the command line.
CH UNDO
Example) Restore the channels 1 and 3 at the specified level to the command line.
> 1 + 3 @ 5 0
> 2@FL
CH UNDO
> 1 + 3 @ 5 0
10.8)
Set CH(s) color
CH number
@COLOR
↑
At this point, the display of F1 to F16 on the screen changes to the comments (color numbers) on
the sheet set on the CC ROLL SETUP screen and the display of levels changes the comments
(color numbers) on the sheet specified for the cue.
Example) Set the color of CH1 to sheet (color number) 1.
> 1
@COLOR F1
10.9)
Keep the color of CH(s) unchanged in this CUE (use the value inherited from the preceding
CUE).
> CH number
Example) Keep the color of CH1 unchanged.
> 1
@COLOR RESET
11) Select heatup channels automatically.
F7 (HEATUP)
The following channels are selected:
Current CUE ≤ the level set on the DEFAULT screen (ACTUAL) in the next CUE ≥ the level set on the
DEFAULT screen (NEXT)
Example) Select the heatup channels for CH1 to CH100 and then those channels' levels to 10%.
> 1 ∼ 100 HEATUP @ 1 0
@FL
F1 to F16
@ COLOR RESET
↑
At this point, the display of F1 to F16 on the screen changes to the comments (color
numbers) on the sheet set on the CC ROLL SETUP screen and the display of levels
changes the comments (color numbers) on the sheet specified for the cue.
11-7
Advertisement
Table of Contents
