Toshiba LICSTAR-IV SE Instruction Manual page 76

BLIND Screen
14.5) Specify the GROUP after the currently specified one.
> NEXT
Example) Set the levels of CHs assigned to GROUP3 to GROUP5 to 100% and then specify
GROUP6.
> GROUP
NEXT
The COMMAND line is displayed as follows:
> GROUP6 @ 5 3
14.6) Specify the GROUP preceding the currently specified one.
> LAST
Example) Set the levels of CHs assigned to GROUP3 to GROUP5 to 100% and then specify
GROUP2.
> GROUP
LAST
The COMMAND line is displayed as follows:
> GROUP2 @ 5 3
15) Assigning the CHs in groups to a PART
15.1) Assign the CHs in groups to a PART. The levels of those CHs are not changed.
> PART PART number
Example) Assign the CHs assigned to GROUP5 to GROUP1.
> PART 1
15.2) Specify the levels of CHs in groups and assign those CHs to a PART.
> GROUP GROUP number
Example) Set the levels of CHs assigned to GROUP5 to 20% and assign those CHs to PART1.
> GROUP
16) Raising or lowering the levels of CHs in group by 1 or 10
16.1) Changing the levels linearly
> GROUP GROUP number
> GROUP GROUP number
> GROUP GROUP number
> GROUP GROUP number
Example) Lower the levels of the CHs assigned to GROUP1 by 10% linearly.
> GROUP
∼
3 5 @FL
↑
This is the level set to the smallest CH number among those assigned to GROUP6 on
the BLIND screen.
∼
3 5 @FL
↑
This is the level set to the smallest CH number among those assigned to GROUP2 on
the BLIND screen.
= GROUP
↵ ↵
= GROUP 5
@ Level
5 @ 2 0 = PART 1
@ +10
@ -10
@ +1
@ -1
1 @ -10
↑
The COMMAND line on the screen displays the levels at the time after @.
↵
GROUP number
= PART PART number
↵ ↵
Raise the levels of the CHs specified on the screen by 10%.
Lower the levels of the CHs specified on the screen by 10%.
Raise the levels of the CHs specified on the screen by 1%.
Lower the levels of the CHs specified on the screen by 1%.
11-10
↵
↵ ↵