Shot Box Register Creation
The term "shot box" refers to a function whereby for each specified region any
snapshot or keyframe effect can be recalled simultaneously. For each region,
any snapshot or keyframe effect number can be specified to be recalled.
There is also a setting to enable or disable the auto run function.
For a shot box overview, see "Shot Box " in Chapter 1 (Volume 1).
Accessing the Shotbox menu
Carry out creation and editing of shot box registers in the Shotbox menu.
To access the Shotbox menu, use the following method.
• In the menu control block, press the top menu selection button [SHOT
BOX].
Creating a shot box register
Use the following procedure.
1
2
64
Shot Box Register Creation
In the Shotbox menu, press VF1 'Register' and HF1 'Store/Recall.'
The Shotbox>Register>Store/Recall menu appears.
In the status area, the settings for each register appear as follows.
Region settings: Appear as "Sxxx" when a snapshot is allocated, and as
"Exxx" when an effect is allocated. (xxx is the register number.) The
register name also appears. If nothing is allocated, nothing appears in
the display.
Register lock setting: When the register is write-protected, an "L"
appears.
Auto run setting: When this is enabled, so that an effect is executed
simultaneously with recall, "AR" appears.
Shot box register name: This shows the shot box register name.
To switch the status area region display, press one of the [Switcher],
[DME], [Misc] indications that appear in the status area.
Switcher: Shows the allocations for M/E-1 ("ME1"), P/P ("PP"), User1
("USR1"), and User2 ("USR2").
DME: Shows the allocations for DME channel 1 ("DME1"), channel 2
("DME2"), channel 3 ("DME3"), and channel 4 ("DME4").
Misc: Shows the allocations for P-BUS ("PBUS"), GPI ("GPI"), Router
("RTR"), Device1 ("DEV1"), and Device2 ("DEV2").