7
Press the [ENTER] button.
This saves the snapshot, and the [STORE] button goes off. The [RCALL]
and [STORE STATS] buttons light.
To cancel a snapshot save operation
After saving a snapshot, to cancel the save, hold down the [STORE STATS]
button and press the [UNDO] button.
Recalling a snapshot from the numeric keypad control block
Use the following procedure.
1
In the numeric keypad control block, press the [SNAPSHOT] button,
turning it on.
This allocates the numeric keypad control block to snapshot operations,
and the [RCALL] button lights.
2
Press the region selection button corresponding to the region for which you
want to recall.
See step 3 (page 52) in "Saving a snapshot from the numeric keypad
control block."
3
Enter the desired register number from the numeric keypad.
See step 5 (page 52) in "Saving a snapshot from the numeric keypad
control block."
The entered register number appears in the display.
4
To set the A/B bus cross-point hold as a temporary attribute, press the
[XPT HOLD] button in the cross-point control block.
For details of temporary attributes, see "Snapshot Attributes" in Chapter
1 (Volume 1).
Notes
• The cross-point hold setting is maintained until you next press the [XPT
HOLD] button.
• Applying temporary attributes does not affect the contents of the
register.
Snapshot Operations From the Numeric Keypad Control Block
53