Setting The Effect Duration - Sony DVS-9000 User Manual

Setting the keyframe duration
You can set the value of the keyframe duration independently for each
keyframe, by the following method.
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect on the keyframe for which you want to set the duration.
The time from this keyframe to the following keyframe is what you set.
3
Press the [KF DUR] button, turning it on.
The display in the numeric keypad control block shows "KF DUR"
followed by the duration of the current keyframe (seconds:frames).
4
Using the numeric keypad in the numeric keypad control block, enter the
timecode value for the keyframe duration, as a maximum of four digits.
For example, to set 9 seconds and 20 frames, enter 920. You can also use
the [TRIM] button to enter a difference value. (See "Entering a difference
value" (page 24).
5
Press the [ENTER] button to confirm the entry.
This changes the keyframe duration to the new setting.
Note
In addition to the above operation, the keyframe duration may also be
automatically changed as a result of changing the effect duration. (See the
next section.)

Setting the Effect Duration

To set the effect duration, use the following procedure.
1
Press the [EDIT ENBL] button, turning it on.
2
Press the [EFF DUR] button, turning it on.
The display in the numeric keypad control block shows "DUR" followed
by the effect duration (minutes:seconds:frames).
35
Time Settings