Sony DVS-9000 User Manual page 100

2
Setting the Source and Destination names
To set the Source and Destination names used in the system, use the following
procedure.
1
2
Setting the button operation mode
Use the following procedure.
1
2
100
Setup Relating to Operations From the Control Panel
Make the following settings as required.
Effect recall mode: To select the initial keyframe state when an effect is
recalled, select [Recall] (do not display the first keyframe) or
[Recall&Rewind] (display the first keyframe) in the <Recall Mode>
group.
Automatic effect saving: To automatically save an effected when it is
recalled after being edited, turn [Effect Auto Save] on.
In the <Source/Dest Name> group of the Panel>Operation menu, select the
names to be used from the following.
SW'er Local: Source names set in the Xpt Assign menu, and fixed bus
names
S-Bus Description: Description names set in the routing switcher
S-Bus Type + No.: Type + No. set in the routing switcher (In this case
always eight characters.)
In the <Name Display Mode> group, select the method of display in the
source name displays.
Auto: Optimize display according to number of characters. A name of up
to two characters appears as two characters in one line. A name of up
to four characters appears as four characters in one line.
Otherwise, up to the first eight characters are shown in two lines.
2 Character: The first two characters appear.
4 Character: The first four characters appear.
In the Panel>Operation> menu, press [Custom Button].
The Custom Button menu appears.
The status area shows a list of the items with their settings.
Make the following settings as required.
[ALL] button: To specify the next transition to be selected by pressing the
[ALL] button in the transition control block, press the next transition
you want to select, turning it on, in the <Next Trans All> group. If