Show Ip Community-Lists; Deny (For Standard Ip Acls) - Dell S4810 Reference Manual

Example
Dell(conf)#ip community-list TestComList
Dell(config-community-list)#

show ip community-lists

Display configured IP community lists in alphabetic order.
S4810
Syntax
show ip community-lists [name]
Parameters
name
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
pre-Version
6.1.1.0
Example
Dell#show ip community-lists
ip community-list ABC
permit local-AS
deny no-advertise
permit no-export
Dell#

deny (for Standard IP ACLs)

To drop packets with a certain IP address, configure a filter.
Syntax
deny {source | any | host {ip-address}}[count [byte]] [dscp
value] [order] [fragments] [log [interval minutes] [threshold-
in-msgs [count]] [monitor]
Access Control Lists (ACL)
(OPTIONAL) Enter the name of the standard or extended IP
community list, up to 140 characters.
EXEC
EXEC Privilege
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the E-Series.
299