Show Interfaces Stack-Unit - Dell S4810 Reference Manual

AutoNegotiation Expansion:
...
Related
show interfaces
Commands
interface.

show interfaces stack-unit

Display information on all interfaces on a specific S-Series or Z-Series stack member.
S4810
Syntax
show interfaces stack-unit unit-number
Parameters
unit-number
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Example
Dell#show interfaces stack-unit 0
GigabitEthernet 0/1 is down, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:4c:f2:82
Pluggable media not present
Interface index is 34129154
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto, Mode auto
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 3w0d17h
Queueing strategy: fifo
Input Statistics:
Interfaces
10MegHalfDplx:
Asym Pause:
Sym Pause:
ParallelDetectionFault: False
— displays information on a specific physical interface or virtual
Enter the stack member number. The range is from 0 to 11
for the S4810.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Current address is 00:01:e8:4c:f2:82
0 packets, 0 bytes
5144 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
False
False
False
779