Statistics Command - Dell S4810 Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.5.1.0
pre-Version
6.1.1.0
Usage The following describes the show ip traffic summary shown in the following
Information
example.
Keyword
unknown
protocol...
not a gateway...
security failures...
bad options...
Frags:
... reassembled
... timeouts
... too big
... couldn't
fragment
...encapsulation
failed
902
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
F10 Monitoring MIB available for the ip traffic

statistics command.

Introduced on the E-Series.
Definition
No receiver for these packets. Counts packets whose
protocol type field is not recognized by Dell Networking OS.
Packets can not be routed; the host/network is unreachable.
Counts the number of received unicast/multicast packets
that could not be forwarded due to:
• route not found for unicast/multicast; ingress interfaces
do not belong to the destination multicast group
• destination IP address belongs to reserved prefixes; the
host/network is unreachable
Unrecognized IP option on a received packet.
IP fragments received.
Number of IP fragments that were reassembled.
Number of times a timer expired on a reassembled queue.
Number of invalid IP fragments received.
Number of packets that could not be fragmented and
forwarded.
Counts packets which could not be forwarded due to ARP
resolution failure. Dell Networking OS sends an arp request
IPv4 Routing