Isis Csnp-Interval - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

level-2-only

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Because the default establishes Level 1 and Level 2 adjacencies, you do not need to

configure this command. Routers in an IS-IS system must be configured as a Level

1-only, Level 1-2, or Level 2-only system.

Only configure interfaces as Level 1 or Level 2 on routers that are between areas

(for example, a Level 1-2 router) to prevent the software from sending unused hello

packets and wasting bandwidth.

isis csnp-interval

Configure the IS-IS complete sequence number PDU (CSNP) interval on an interface.

isis csnp-interval seconds [level-1 | level-2]

To return to the default values, use the no isis csnp-interval [seconds]

[level-1 | level-2] command.

Intermediate System to Intermediate System (IS-IS)

You can form a Level 2 adjacencies when other Level 2 or

Level 1-2 routers and their interfaces are configured for Level

1-2 or Level 2. Level 1 adjacencies cannot be established on

this interface.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

Interval of transmission time between CSNPs on multi-

access networks for the designated intermediate system. The

range is from 0 to 65535. The default is 10.

(OPTIONAL) Independently configures the interval of time

between transmission of CSNPs for Level 1.