Internet Group Management Protocol
(IGMP)
The IGMP commands are supported by the Dell Networking operating software on the S4810 platform.
This chapter contains the following sections:
•
IGMP Commands
•
IGMP Snooping Commands
IGMP Commands
Dell Networking OS supports IGMPv1/v2/v3 and is compliant with RFC-3376.
Important Points to Remember
•
Dell Networking OS supports protocol-independent multicast-sparse (PIM-SM) and protocol-
independent source-specific multicast (PIM-SSM) include and exclude modes.
•
IGMPv2 is the default version of IGMP on interfaces. You can configure IGMPv3 on interfaces. It is
backward compatible with IGMPv2.
•
On the S-Series, the maximum number of interfaces supported 31.
•
There is no hard limit on the maximum number of groups supported.
•
IGMPv3 router interoperability with IGMPv2 and IGMPv1 routers on the same subnet is not supported.
•
An administrative command (ip igmp version) is added to manually set the IGMP version.
•
All commands previously used for IGMPv2 are compatible with IGMPv3.
clear ip igmp groups
Clear entries from the group cache table.
S4810
Syntax
clear ip igmp groups [group-address | interface]
Parameters
group-address
interface
interface
Internet Group Management Protocol (IGMP)
(OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
Enter the following keywords and slot/port or number
information:
•
For a Port-Channel interface, enter the keyword port-
channel then the slot/port information. The range is
from 1 to 128.
23
709