Service Timestamps - Dell S4810 Reference Manual

Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.5.1.0
Usage Messages can contain an unlimited number of lines; however, each line is limited
Information to 255 characters. To move to the next line, use <CR>. To send the message use
CTR-Z; to abort a message, use CTR-C.

service timestamps

To debug and log messages, add time stamps. This command adds either the uptime or the current time
and date.
S4810
Syntax
service timestamps [debug | log] [datetime [localtime] [msec]
[show-timezone] | uptime]
To disable timestamping, use the no service timestamps [debug | log]
command.
Parameters
debug
log
datetime
localtime
msec
show-
timezone
uptime
Defaults Not configured.
Command CONFIGURATION
Modes
126
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter the keyword debug to add timestamps to
debug messages.
(OPTIONAL) Enter the keyword log to add timestamps to
log messages with severity from 0 to 6.
(OPTIONAL) Enter the keyword datetime to have the
current time and date added to the message.
(OPTIONAL) Enter the keyword localtime to include the
localtime in the timestamp.
(OPTIONAL) Enter the keyword msec to include milliseconds
in the timestamp.
(OPTIONAL) Enter the keyword show-timezone to include
the time zone information in the timestamp.
(OPTIONAL) Enter the keyword uptime to have the
timestamp based on time elapsed since system reboot.
Control and Monitoring