Dell S4810 Reference Manual page 936

tunnel tunnel-
id
vlan
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.
(0.0)
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.7.0
Version 8.5.1.0
Version 8.4.2.1
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0
Usage The Management port is enabled by default (no shutdown). If necessary, use the
Information ipv6 address command to assign an IPv6 address to the Management port.
Example
Dell#show ipv6 interface tengigabit 0/12
TenGigabitEthernet 0/12 is up, line protocol is up
936
(OPTIONAL) View information for a tunnel interface.
(OPTIONAL) View information for IPv6 VLANs.
EXEC
EXEC Privilege
Added support for tunnel interface.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S-Series.
Introduced on the E-Series ExaScale. Added support for the
managementethernet slot/port parameter.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
IPV6 is enabled
Link Local address: fe80::201:e8ff:fea7:497e
Global Unicast address(es):
100::2, subnet is 100::/64 (MANUAL)
Remaining lifetime: infinite
Global Anycast address(es):
Joined Group address(es):
ff02::1
ff02::2
ff02::1:ff00:2
ff02::1:ffa7:497e
ND MTU is 0
ICMP redirects are not sent
DAD is enabled, number of DAD attempts: 3
ND reachable time is 39610 milliseconds
ND base reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised retransmit interval is 0 milliseconds
IPv6 Basics