Dell S4810 Reference Manual page 741

Hide thumbs Also See for S4810:

Table of Contents

Dell(conf-if-Tegi-0/1)#show config

interface GigabitEthernet 0/1

no ip address

no negotiation auto

flowcontrol rx off tx on

This Example shows how Dell Networking OS negotiates the flow control values

between two Dell Networking chassis connected back-to-back using 1G copper

LocRxConf LocTxConf RemoteRxConf RemoteTxConf

LocNegRx LocNegTx RemNegRx RemNegTx

Speeds less than 1 Gig cannot be configured when the asymmetric flow control

configuration is on. The following error is returned:

Can't configure speed <1G when Asymmetric flowcontrol is on,

config ignored

Dell Networking OS only supports rx on tx on and rx off tx off for

speeds less than 1 Gig (Symmetric).

NOTE: If you use the disable rx flow control command, Dell

Networking recommends rebooting the system.