Commands To Configure Dns; Ip Name-Server - Dell S4810 Reference Manual

Commands to Configure DNS

To configure the Domain Names Systems (DNS) on the system, use the following commands:

ip name-server

Configures the name server IP addresses for VRF. Using this command, you can configure up to a
maximum of six IP addresses per VRF.
S4810
Syntax
ip name-server [vrf vrf-name] ip-address [ip-address2] [ip-
address3] [ip-address4] [ip-address5] [ip-address6]
To undo the name server ip address configuration for VRF, use the no ip name-
server [vrf vrf-name] ip-address command.
Parameters
vrf vrf-name
ip-address [ip-
address2] [ip-
address3] [ip-
address4] [ip-
address5] [ip-
address6]
Defaults None
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage Use this command to associate name server IP addresses to a specific VRF.
Information
Example
•
•
5.5.5.5 6.6.6.6 7.7.7.7
632
(Optional) Enter the key word vrf and then the name of the
VRF to configure the name server IP addresses for that VRF.
Enter the IP address of the name server in dotted decimal
format.
NOTE: Use the additional ip-address parameters (ip-
address2 to ip-address6) in a sequential order to
specify up to a maximum of six IP addresses per VRF.
Introduced on the S-Series and Z-Series.
Dell(conf)#ip name-server vrf jay 2.2.2.2
Dell(conf)#ip name-server vrf jay 2.2.2.2 3.3.3.3 4.4.4.4
Dynamic Host Configuration Protocol (DHCP)