Table of Contents
Advertisement
2 Plug the remote key pad connector into the connector (REMOTE) on the IV-S20 main housing.
3 Connect the monitor to the monitor connector (VIDEO: RCA jack) on the IV-S20 main housing
using the monitor cable (supplied with the IV-S20, IV-S20N, and IV-S20M) and a conversion con-
nector (supplied with IV-S20, IV-S20N, and IV-S20M). If the monitor has an RCA jack, the conver-
sion connector is not required.
- Use a monitor with either an EIA or NTSC compatible video input terminal.
- Gently push the monitor connector straight in.
BNC connector
Monitor
Conversion
connector
RCA jack
Monitor
- If you need a monitor cable longer than 2 m, you can purchase a one at a video store.
4
For details about connecting and installing the camera, see page 6-19 and after.
Leave enough space around the IV-S20
In order to connect camera cables, the remote key pad cable, monitor cable and D-sub connector to
the IV-S20, the following space (min.) is required.
148mm
9mm
130mm
INPUT
X0
X1
X2
X3
X4
X5
Y0
Y1
Y2
Y3
Y4
Y5
OUTPUT
VIDEO CAMERA1 CAMERA2
Camera cable
Monitor cable
(Cable length 2 m)
9mm
IV-S20
· Do not bend the camera cables repeatedly.
POWER
POWER
· Make sure the installation location allows
X6
C(+)
+24V
0V
Y6
Y7
BUSY
C(-)
RS232C/RS422
REMOTE
6-9
Installation Conditions and Method
Monitor connector (VIDEO)
enough space for the input/output wires going to
the I/O terminal block and the power terminal
block on the IV-S20.
IV-S20 main
housing
6
Advertisement
Table of Contents
