Table of Contents
Advertisement
Setting and Operating Outlines
[4] Image display
(1) Image display modes
There are two image display modes, i.e. through (moving images) and freeze (still image).
Display
mode
Through
Freeze
The operation (run) screen is only displayed in the FREEZE MODE, and the "ADJUST GAIN &
OFFSET" screen is only displayed in the through mode.
- Status display
At the upper right of the screen, "T" is displayed in the through mode, and "F" is displayed in the
freeze mode. (On the MAIN OPS MENU only, the word FREEZE is displayed.)
[Run screen]
7
Notes
- To register a reference image for gray scale searches, and to test evaluation conditions
If these operations are started in the through mode, the message CHANGE TO FREEZE
MODE will be displayed. Before starting these operations, change to the image F (freeze
display mode.)
- Displaying binary images
In the through mode, the image captured when the freeze mode is invoked while be
displayed after binary conversion.
(2) Adjustment of image brightness
The image brightness can be adjusted on any setting screen (other than the run screen) output on
the monitor.
- Purpose
This function is used when the image is so bright that the characters and pattern display are
difficult to see.
- Status display
The brightness level, "H" or "L," is displayed in the upper right corner of the screen.
Level
display
- Examples of brightness displays
(At H level)
· A single image taken by a camera is displayed.
· This mode is used for adjusting the camera focus, adjusting an image, and moving
a workpiece during testing.
· When a measurement trigger is input, and an image is captured, the still image is
displayed.
· This mode is used for setting measurement conditions, while looking at the still
image, and for performing settings on the MAIN OPS MENU.
(TYPE00)
F L C1ALLC2NO
OK
MEAS. XXXXXXms
MEAS1 CAM1 MEAS-BIN-AREA
Shown in freeze mode
The image captured by the camera is displayed at the original brightness of the image.
H
L
The image captured by the camera is displayed at half the brightness of the original.
Description
[Setting screen]
OBJECT TYPE COND
VX.X
OBJECT TYPE NO.
EDIT
TITLE REGISTRATION (TO NEXT SUB-MENU)
MEAS.0, CAMERA1
POS. ADJ.CAMERA1
Description
(At L level)
7-8
F C1 H
00(0 15)
COPY(
TYPE00) INITIALIZE
NO (TO NEXT SUB-MENU)
NO ADJ. [REG. 0-1PNTSXY
In freeze mode
("T" in through mode)
Advertisement
Table of Contents
