Setting (Operating) Procedure - Sharp IV-S20 User Manual

(2) When the measurement is started by a CCD trigger or a parallel I/F signal and the results
are output by a general purpose serial I/F signal
When the IV-S20 responds, data in a specified block is output after the output data (block 0) from
the measurement No. 0 to 3, in response to the measurement run command 2 (processing code
11 ).
(H)
Response
: 1 1
RC RC
(H) (L)
- See page 13·5 for details about 1 and 2.
Note: The response returned by the measurement run command 2 (processing code 11
not contain the specified block.

[2] Setting (operating) procedure

On the [MAIN OPS MENU], move the cursor to SET-SCRN, and press the SET key.
- On the [SYSTEM SETUP] menu, move the cursor to item 2 OBJECT TYPE COND
and press the SET key.
- On the [OBJECT TYPE COND] menu, move the cursor to item t SYSTEM IN/OUT
and press the SET key.
[OBJECT TYPE I/O]
1MONITOR LIGHT LVL
2LIGHT LEVEL COND
3TRIGGER CCD START REG.NO YES(BIN AVG-LIT-LVL)
4CCD TRIGGER COND (TO NEXT SUB-MENU)
5COMPUTER LINK OUT BLOCK-00(MESR-O CMR01)
1
&SERIAL OUTPUT
6SHUTTER SPEED
7STORE REF IMAGE
8UPPER MENU
1. Move the cursor to item 5 COMPUTER LINK OUT & SERIAL OUTPUT with the up and
down keys, and press the SET key.
2. Enter the program No., camera No. and block No. of the measurement data to be output,
using the left, right, up and down keys.
- Specify a block number to be returned in addition to block 0 (00).
If block 00 is specified, data from block 00 will not be returned a second time.
3. After the settings are complete, press the SET key.
Object Output evaluation
Measurement 0
type results
Camera 1 Camera 2
Y0 Y1 Y15
Data from Data from
measurement 1 measurement 2
data 2 data 2
CAM1(1~2) NO YES
(TO NEXT SUB-MENU)
1/00060(1/30~1/10000)
MOVE UP.L(224,208) LO.R (287, 271) REG. DISP
11-21
Setting the Input/Output Conditions
1
Measurement 0
Camera 1
data 2
Data from Data in the
measurement 3 specified
data 2
block
2
Camera 2
data 2
SC SC CR
(H) (L)
) will
(H)
11