Table of Contents
Advertisement
Existence inspection by point measurement
Continued from the previous page
1 POINT SIZE :
2 STO PNT POSITIONS 000(0 to 255 )REG.NO YES
3 START POINT POS MOVE( , )
4 BLOCK LAYOUT
5 BLOCK SPACING
6 STORE BLOCK COND EXEC
7 DELETE BLOCK COND EXEC
8 UPPER MENU
· You can switch between displaying all of the headings together and displaying each one
separately using the ESC key.
1 POINT SIZE
2 STO POSITIONS
3 START POINT POS
4 BLOCK LAYOUT
5 BLOCK
SPACING
9
6 STORE BLOCK COND
7 DELETE BLOCK COND
8 PRIOR MENU
[Example of a block registration]
Return to the [MEASURING COND] (measurement condition) menu, and select item
5 UPPER MENU
Item 7 EVALUATION COND (evaluation condition) in the [TYPE00 to MEAS1 to 3] menu.
When BIN-CONV (binary) is selected
as the processing mode.
Continued on the following page
Y-08 X-08(2 to 32)
001 001
Y-004 X-004
Menu
Set the size of the point (vertical and horizontal), within the range of
2 to 32, in units of 2 pixels.
Set points individually, and select NO/YES to store each.
· There are a maximum of 256 point registration locations (0 to 255)
for the BIN-CONV (binary) mode and 128 point registration locations
(0 to 127) for the AV-LIGHT-LEVEL (average light level) mode.
· The point identifying a block of pixels is the starting point.
Set the starting point position.
· A group of pixels used as a point are treated as a single pixel.
· The point identifying a block is the starting point.
Set the number of vertical objects times the number of horizontal
objects that will be registered as a block.
Set the vertical and horizontal intervals for points in the objects that
will be registered as a block, in unit of 1 pixel. (Min. 0 pixel.)
Store the settings as a block.
Delete all of the registered points in a block.
Returns you to the [MEASURING COND] (measurement condition)
menu.
Set the starting point in items 2 and 3 above.
(Binary image)
Enter 002 (vertical) × 003 (horizontal) in item 4 BLOCK LAYOUT,
and enter the vertital (Y) and horizontal (X) intervals in item
5 BLOCK SPACING. Then select item 6 STORE BLOCK COND
to store the settings for the block.
This value will be 127 when AV-LIGHT-
LEVEL (average light level) is selected
for the processing mode.
Setting details
When AV-LIGHT-LEVEL
(average light level) is selected as the
processing mode.
Go to page 9·112
9-110
X
X
Y
Advertisement
Table of Contents
