Table of Contents
Advertisement
Setting and Operating Outlines
7-2 Screen specifications
[1] Operation (run) screen
Supply power to the IV-S20 main housing, and the MAIN OPS MENU (startup screen) will be
displayed on the monitor.
- Before applying the power, make sure that the power cable, monitor cable, camera cables, and
remote key pad have been connected to the IV-S20 main housing.
Object type No. (00 to 15) and the name assigned by the user for each object type
7
Display of the results of the programmable output (auxiliary relay C116)
If C116 has not been set, the results of C112 are output. (See page 10·7)
Display
(Error
message)
FL C1 ALL C2NO
LOCK VX.X
C1 002.2 OK
· This item is displayed when the illuminance monitor MONITOR LIGHT LVL on the
[OBJECT TYPE I/O] menu has been set to "YES." (See page. 9·115.)
Measurement No. (0 to 3), camera No. (1 or 2) and measurement program name
(TYPE00)AREA1
OK
MEAS. XXXXXXms
MEAS0 CAM1 POS-DEVIATION
X0 6
Y0 7
:
:
MSR-CHNG REG-CHNG PC-MONTR SET-SCRN MANL-TYP-CHG
"OK" is displayed when all of the individual evaluation results are acceptable.
OK
"NG" is displayed if any single evaluation result is unacceptable.
NG
An error code and the measurement number that caused the error are
displayed on the upper line. The error message is displayed on the lower line.
Operation status display:
sampling
Output monitor status
Camera 1 (C1)/camera 2 (C2) = All/upper/middle/lower/none
Image brightness: H = Original brightness of captured image
L = Brightness reduced to half that in the captured image
Image display mode: F = Freeze mode N = No camera input
Flashes during communications
System program version number
Run menu lock ("LOCK" is not displayed while the screen is unlocked.)
Average density during measurement, and judgment (OK/NG)
Camera No. (C1 = camera 1, C2 = camera 2)
F L C1ALLC2NO
LOCK VX.X
C1=002.2 OK
C2=100.0 OK
BUSY
:
Description
flashing = running,
7-2
Select BUSY or READY on
the [I/O CONDITIONS]
menu.
flashing = CCD trigger
Advertisement
Table of Contents
