Table of Contents
Advertisement
Object identification (labeling) by binary conversion
Continued from the previous page
[Window settings]
· In order to set a window it is necessary to freeze the image.
· First freeze the image. Then operate the camera normally. Finally, freeze the image again. The first
frozen image that was taken will be converted to binary values and this will be the final binary image.
The second frozen image that was taken may also be converted to a binary image by repeating
steps 1 to e above.
[Example of recording an image]
Measurement window
(rectangular)
Mask window
(rectangular)
[MEASURING COND] (TYPE00-MEAS.1-LABEL-BIN-OBJ)
1REGST NO.
2BINARY AREA COND (TO NEXT SUB-MENU)
3FIND CENT/GRAVITY NO YES
4MAIN AXIS ANGLE NO YES
5FILLET DIAMETER NO YES
6PERIMETER LENGTH NO YES
7UPPER MENU
· Set measurement items 3 to 6 to NO or YES, as desired.
Center of gravity, main axis angle
9
0, 0
Y
Fillet width
Fillet width (horizontal)
Peripheral
Continued on the following page
00(0~3) REG.NO YES
Center of gravity (X1, Y1)
· Calculated from the area and the position of each object.
X1
· (X1, Y1)=( x/N,
Main axis angle
Angle between the longitudinal and horizontal directions
with the center of gravity treated as the base.
(511, 479)
The number of pixels in the
boundary line of an object
(Inclination: √2 times)
·The binary image will be the contents
of the measurement window, after the
portion excluded by the mask window
has been removed.
y/N) N: Area
9-102
Advertisement
Table of Contents
