Table of Contents
Advertisement
Operation Examples (Area measurement by binary conversion)
Continued from the preceding page
(9) Setting the evaluation conditions and results output
1. On the [TYPE00-MEAS1] (type: 00, measurement: 1) menu, move the cursor to 7
EVALUATION COND (evaluation conditions) and press the SET key.
- The [EVALUATION COND] menu will be displayed.
2
3
3
6
2. Move the cursor to 1 REGST NO. (register number) and press the SET key. Select the
desired number, in this case 00, using the up and down keys, and press the SET key.
3. Move the cursor to 2 AREA (size) and press the SET key.
4. Move the cursor to the upper limit value with the left and right keys, and press the SET key.
- Select the digit you want to change with the left and right keys, and enter the value 002000
with the up and down keys.
- After defining the upper limit, press the SET key.
5. Move the cursor to OUT (output) with the left and right keys.
· Select Y0 with the up and down keys, and press the SET key.
- After completing the settings, press the ESC key.
6. Move the cursor to 4 UPPER MENU and press the SET key.
- The screen will return to the [TYPE00-MEAS1] (type :00, measurement: 1) menu.
(10) Returning to the MAIN OPS MENU
1. Press the ESC key.
- The screen will return to the [OBJECT TYPE COND] (conditions of object type) menu.
2. Press the ESC key, again.
- The screen will return to the [SYSTEM SETUP] menu.
3. Press the ESC key.
- The screen will return to the MAIN OPS MENU.
Continued on the following page
[EVALUATION COND] (TYPE00-MEAS.1-MEAS-BIN-AREA)
1REGST NO.
00(0~15)
2AREA
000000~245760
3MAKE A TEST RUN
(SET KEY)
4UPPER MENU
2AREA
000000~002000
OUT
Y0
- Move the cursor to 9 SAVE IN FLASH MEM (save data in flash memory) or 0
OPERATIONS and press the SET key.
- The following message will be displayed on the upper part of the screen.
DATA SAVE? (Do you want to save data ?) (YES=[SET]/NO=[ESC])
- Press the SET key.
- The data saving operation will start, and the progress will be displayed on the bottom
of the screen.
REFERENCE IMAGE
SYSTEM I/O
MEAS CONDITIONS
When the data has been saved in the IV-S20 flash memory, the display will change
from "SAVING" to "SAVING COMPLETE"
Note:
- If the ESC key is pressed, the settings you entered will not be saved in the IV-S20
flash memory. In this case, if the power to the IV-S20 main housing is turned OFF, or
if the type No. is changed, the settings will be deleted.
- If the cursor was moved to 0 OPERATIONS in step 2 above, the screen will
automatically return to the MAIN OPS MENU.
[OUT]
NO
5
4
SAVING
3-6
Advertisement
Table of Contents
