Table 3.17 Ports And Leds Of The Plim2 - Samsung OfficeServ 7200 Technical Manual

OfficeServ 7200
TECHNICAL MANUAL
3.3.14 PLIM2 (PoE LAN INTERFACE MODULE)
PoE LAN Interface Module (PLIM2) can use Power Supply Unit (PSU) or an external rectifier
and selects the power supply source by using shunt pins.
FRONT VIEW OF PLIM2 BOARD
The front view of the PLIM2 data module is shown in the picture below.
The front panel components of the PLIM2 have the functions below:
Ports & LEDs
P1~P16
Left LED of each port
Right LED of each port
JUMPER SETTINGS
• When using the internal rectifier the shunt pins (J2, J3 and J4) are connected between pin
1 and pin 2. Since the available capacity is limited to PSU, the use of ports is limited to 16
ports and the use of digital phones is, also, limited. (For more information on the limitation
about the use of digital phone phones in accordance with the use of PLIM2 port, contact
your dealer.)
• For the use of an external rectifier: The shunt pins (J2, J3 and J4) are connected between
pin 2 and pin 3. There is no restriction on the use of an external rectifier because each of
them can supply the current of 10 A. Limit each current running through PLIM2 ports
below 0.1A and in the module below 1.6 A.
Figure 3.38 Front View of the PLIM2 Board

Table 3.17 Ports and LEDs of the PLIM2

Function Description
RJ-45 (10/100 Base-T) LAN ports (Full Duplex).
The LED ON indicates if the link is operating.
- Blink: The link is transmitting/receiving data packets.
The LED indicates if the port of 10 Base-T/100 Base-Tx is operating.
- Off: The port is operating as 10 Base-T port.
- On: The port is operating as 100 Base-T port.
3.37
Table of Contents
Home Page
INSTALLATION
PART 3 MAY 2010