Samsung OfficeServ 7200 Technical Manual page 108

OfficeServ 7200
TECHNICAL MANUAL
KDB-SLI
This daughterboard can be installed only in the DCS 12 or DCS 24 button keyset. Before
performing this procedure, unplug the line cord from the keyset and remove the base wedge.
Place the keyset face down on a soft surface and remove the four base retaining screws
Figure 7.11). Separate the base from the keyset and place the keyset aside. Attach the KDb-SLI
to the keyset base with the six screws that are supplied
that the modular socket shows through the access hole in the base
the base assembly over the keyset and plug the ribbon cable into the socket on the keyset
PCB (see Figure 7.14) while making sure no damage occurs to the keyset PCB. Reattach the
base to the keyset and test to ensure normal keyset operation.
RETAINING SCREWS
RETAINING SCREWS
Figure 7.11 Keyset Base
(see Figure 7.15).
7.10
Table of Contents
Home Page
INSTALLATION
PART 7 MAY 2010
(see
Take care to ensure
(see Figure 7.13). Invert