Table 3.14 Ports And Leds Of The 8Sli/8Sli2 - Samsung OfficeServ 7200 Technical Manual

OfficeServ 7200
TECHNICAL MANUAL
Front panel components of the 8SLI/8SLI2:
Ports & LEDs
P1~P8
P1~P8 LED
• Port 1 (P1) supports Power Failure Transfer function
•
See Section 7.1.2 for port
• Do not connect devices with a total REN greater than 5.0 to this card.
3.3.12 WIM (WAN INTERFACE MODULE)
This board provides data router functionality to the OfficeServ 7200. It offers a variety of
interfaces for connecting to external and internal data networks.
A WIM can be installed in either slot 1 of the main cabinet or slot 1 of the expansion cabinet.
Only ONE WIM board can be installed per system.
If a PLIM (PoE LAN Interface Module) needs to be a managed switch via the OfficeServ 7200
backplane (Method 2), then it must be installed in slot 2, right next to the WIM which is in slot 1.
PLIM management can also be accomplished using an Ethernet cable (Method 1).

Table 3.14 Ports and LEDs of the 8SLI/8SLI2

Function Description
Station ports for analog phones.
These LEDs indicate the operation status of the ports.
- Off: The station is not active on a call.
- On: The station is active on a call.
Pinout/Wiring.
Figure 3.33 Jumper Setting of WIM Board
3.31
Home Page
(Refer to Section 3.4).
Method 1: PLIM is connected
to WIM via patch cable from
WIM to Ethernet port on PLIM
front panel.
Method 2: WIM is connected
to PLIM through the back
plane thus saving an Ethernet
port on the PLIM front panel.
For this connection method
the PLIM must be installed
in SLOT 2.
Table of Contents
INSTALLATION
PART 3 MAY 2010