OfficeServ 7200
TECHNICAL MANUAL
2) Use the electrical drill to make holes where the screw holes were marked.
3) Select appropriate screws, toggle bolts, or plastic anchors to suit the selected mounting
surface.
4) Secure the bracket to the wall using appropriate hardware.
5) There are two screws in two of the four holes at the bottom of the OfficeServ 7200 cabinet as
shown below. To install on the wall, loosen the two screws to approximately 2mm as shown in
Figure 2.10.
Figure 2.8 Wall Installation (2)
Figure 2.9 Wall Installation (3)
2mm
Figure 2.10 Wall Installation (4)
2.6
Table of Contents
Home Page
INSTALLATION
PART 2 MAY 2010