Kenwood NEXEDGE NX-200 Function Reference page 541

26 MODE
26.4 Overwriting the Firmware (Firmware Programming Mode)
Note
• Refer to the service manual for instructions on how to operate the transceiver in Clone Mode, and for details on the Clone function.
• To end Clone Mode, the transceiver must be turned OFF.
• The following data cannot be copied in Clone Mode:
• Tuning Data
• Embedded Message with Password
• KENWOOD ESN Data
• MPT ESN Data
• NXDN ESN Data
• If the data is copied to a transceiver having a different firmware version number, this may result in an error or a failure of the transceiver
to function correctly. In such a case, the cloned transceiver operation must be verified prior to using this transceiver on a regular basis.
Configuration using KPG-111D/ DN
Configuring whether to permit the use of Clone Mode (
26.4 Overwriting the Firmware (Firmware Programming Mode)
Firmware Programming Mode can be used to write the firmware to the transceiver.
Operating the Transceiver
1
Turn the transceiver ON while pressing and holding the
NX-300S).
The LED lights orange, and then the transceiver enters Firmware
Programming Mode.
Note
• Refer to the service manual for instructions on how to operate the transceiver in Firmware Programming Mode, and on how to write the
firmware to the transceiver.
• To end Firmware Programming Mode, the transceiver must be turned OFF.
• If no firmware is written to the transceiver, the transceiver enters Firmware Programming Mode when the transceiver is turned ON.
Configuration using KPG-111D/ DN
Configuring whether to permit the use of Firmware Programming Mode (
FUNC (K)/Ver 4.00
See FPRG 8.10.2 Common Page 2 Tab)
Menu ([ ]) key (or the
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
FPRG 8.10.2 Common Page 2 Tab)
See
AUX key for NX-200S/
Mobile
CONTENTS INDEX 507