Kenwood NEXEDGE NX-200 Function Reference page 521

22 FUNCTION PORTS
22.2 D-sub 25-pin Connector (Mobile Only)
Function Name
For a Conventional Group:
The output port is active while the received QT tone, DQT code (Analog), or RAN code (NXDN) matches
the QT tone, DQT code (Analog), or RAN code (NXDN) preconfigured for the transceiver. If QT/DQT
Decode is not configured, the output port is active while the transceiver is receiving a carrier. If RAN
Decode is not configured, the output port is active while the transceiver is receiving a RAN code.
TOR Otherwise, the output port is inactive.
For an LTR Trunking system:
The output port is active while the transceiver is receiving the GID. Otherwise, the output port is inactive.
For an NXDN Trunking system:
The output port is active while the transceiver is unmuting the speaker on a traffic channel. Otherwise, the
output port is inactive.
The output port for TOR or Channel Busy status is active while the conditions to activate the TOR or the
TOR or Channel Busy conditions to activate the Channel Busy are satisfied. If conditions to activate the TOR and Channel Busy are
not satisfied, the output port for TOR or Channel Busy status is inactive.
The output port is active while the transceiver does not accept a remote control request from an external
device. The output port is active while the transceiver is in the following situations.
 The output port is active regardless of the configuration for Data Override while the transceiver is in the
Channel Busy
 If Data Override is disabled, the output port is active while the transceiver is in the following states: (Refer
The output port is active if there is no available channel on the repeater in an LTR Trunking system.
System Busy
Otherwise, this port is inactive.
The port output is changed with the state of the AUX A key. An external device connected to the AUX A port
AUX A
can be controlled.
The port output is changed with the state of the AUX B key. An external device connected to the AUX B port
AUX B
can be controlled.
PTT Output The output port is active while the PTT switch is being pressed. Otherwise, this port is inactive.
TXS The output port is active while the transceiver is transmitting. Otherwise, this port is inactive.
FUNC (K)/Ver 4.00
following states: (Refer to 18.4 Prioritizing Data Communications Using an External Device (Data
Override) on page 427.)
• While the transceiver is transmitting (including while a link is established in an LTR Trunking system)
• While Public Address is used
• While the transceiver is initiating a System Search
• While the transceiver is in Emergency Mode
• While the transceiver is in Transceiver Password Mode
• While the transceiver is recording a message in Auto Reply Message
• While the transceiver is in the Stun state
• While the transceiver is on an NXDN channel or GID
to 18.4 Prioritizing Data Communications Using an External Device (Data Override) on page
• While the transceiver is proceeding the Auto Telephone Search
• While the transceiver is in Function Mode
• While Public Address is used
• While the transceiver temporarily migrates to a channel or GID by a user pressing one of the Direct
CH/GID 1 to Direct CH/GID 5 keys or Home CH/GID or CH/GID Recall key
Description
CONTENTS
427.)
INDEX 487