Kenwood NEXEDGE NX-200 Function Reference page 287

10 ANALOG CONVENTIONAL SYSTEM
10.1 Initiating Voice Communications (Basic Transmission and Reception)
2
Release the Squelch Off Momentary
The " " icon disappears. For NX-200S/ NX-300S, Key Beep B
sounds from the transceiver.
On a channel where QT tone or DQT code is configured, the
transceiver restores Signaling Squelch, and on a channel where
no QT tone or DQT code is configured, the transceiver restores
Carrier Squelch.
Note
• Pressing the Squelch Off key or the Squelch Off Momentary key while the Optional Signaling matches resets the matching state of
the Optional Signaling.
• If Squelch Off becomes enabled during the scan, the transceiver pauses scanning on a channel where the transceiver is scanning, and
then unmutes the speaker. The transceiver does not resume scanning until Squelch Off is disabled.
• If Squelch Off is enabled on a channel where "Mixed" is configured for Channel Type, the transceiver mandatory unmutes the speaker.
White noise is audible if no carrier is present. In this case, QT tone, DQT code, or RAM code will be disabled. If the transceiver
receives an analog signal, the transceiver unmutes the speaker only with a carrier. The transceiver unmutes the speaker when the
transceiver receives a digital signal even if the received RAN code does not match the RAN code preconfigured for the transceiver.
Configuration using KPG-111D/ DN
Assigning functions to the PF keys on the transceiver (
Adjusting the Reception Sensitivity of the Transceiver (Squelch Level)
Squelch Level is the threshold receive level by which the transceiver can determine that the received signal has a carrier.
If the received signal is weak, a low (decreased) Squelch Level value must be configured. If unwanted weak signals exist,
raising (increasing) the Squelch Level improves the quality of communication.
Pressing the Squelch Level key changes the Squelch Level.
Or, pressing the Menu key causes the transceiver to enter Menu Mode, and then Squelch Level can be changed by
selecting "Squelch Level". (Refer to
Note
This function is unavailable for NX-200S/ NX-300S.
FUNC (K)/Ver 4.00
key.
See
Table 10-1 Squelch Level
0
Range
Mute function
completely disabled
Step
3.4 Using Menu Mode on page
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
FPRG 8.12 Key Assignment Window)
1 to 9
Low  High
1
23.)
CONTENTS
Mobile
INDEX 253