Kenwood NEXEDGE NX-200 Function Reference page 188

8 NXDN CONVENTIONAL SYSTEM
8.9 Sending and Receiving a Status Message (Status Call)
4
Press the Side 2 key (NX-200/ NX-210/ NX-300/ NX-410/ NX-411), the
switch.
The transceiver sends the Status Message.
If the Status Message is properly sent to the target transceiver,
"COMPLETE" appears.
Note
For details on the information displayed on the main display during transmission in an NXDN Trunking system, refer to
during transmission on page
Configuration using KPG-111D/ DN
• Assigning functions to the PF keys on the transceiver (
• Assigning functions to the Keypad Operation on the transceiver (
• Configuring the Manual Dialing to be enabled or disabled (
Receiving a Status Message
A received Status Message is transferred in the following way.
Status Message
The received Status Message appears on the main display.
If "Fixed" is configured for Message Display Type, only Status Message appears.
Display
The received Status Message appears on the main display for 3 sec and ID Name appears for 2 sec
alternately if "Alternate" is configured for Message Display Type.
Alert Tone Alert Tone sounds if the transceiver receives a Status Message.
The transceiver sends the received Status Message using a serial command. This message is sent to an
PC Command external device that is connected to the transceiver, such as a PC. (Refer to
Message from the Communication Port (Status Message Serial Output) on page
FUNC (K)/Ver 4.00
207.
Table 8-13 Transferring a Status Message
Square
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
See FPRG 8.12 Key Assignment Window)
See FPRG 8.12.2 General Tab)
See FPRG 8.19.2 General 1 Tab)
Description
CONTENTS
key (Mobile), or the PTT
Mobile
Mobile
 Display
Sending the Received Status
159.)
INDEX 154