Kenwood NEXEDGE NX-200 Function Reference page 539

26 MODE
26.2 Adjusting the Transmit and Receive Capabilities of the Transceiver (Panel Tuning Mode)
Note
• Refer to the service manual for instructions on how to operate the transceiver in Panel Test Mode, and on how to test transmit and
receive capabilities.
• To end Panel Test Mode, the transceiver must be turned OFF.
• The transceiver cannot enter Panel Test Mode while Stun is enabled.
Configuration using KPG-111D/ DN
Configuring whether to permit the use of Panel Test Mode (
26.2 Adjusting the Transmit and Receive Capabilities of the
Transceiver (Panel Tuning Mode)
Panel Tuning Mode can be used to adjust transmit and receive capabilities of the transceiver by using the operation panel
of the transceiver.
Note
This function is unavailable for NX-200S/ NX-300S.
Operating the Transceiver
1
Turn the transceiver ON while pressing and holding the
A Power-on Tone sounds from the transceiver, and then the
market code of the transceiver and battery type appear for 2 sec.
The transceiver enters Panel Test Mode after a lapse of 2 sec.
FUNC (K)/Ver 4.00
FPRG 8.10.2 Common Page 2 Tab)
See
Back key.
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
CONTENTS
Mobile
Mobile
INDEX 505