Kenwood NEXEDGE NX-200 Function Reference page 237

9 NXDN TRUNKING SYSTEM
9.4 Using NXDN ID to Initiate a Selective Call
9.4 Using NXDN ID to Initiate a Selective Call
An individual call and group call are available by using NXDN IDs. In addition, a message can be sent to a specified target
ID in various types of message communications.
Available Calls
The following various types of calls can be used in an NXDN Trunking system. For transceiver operations and behaviors,
refer to the instructions of each call type.
• Individual Call (Transmission Trunked)
• Group Call (Transmission Trunked)
• Individual Call (Message Trunked (Enhanced))
• Group Call (Message Trunked (Enhanced))
• Broadcast Group Call
• Status Call
• Short Data Call
• Long Data Call
For a Individual Call and Group Call, the transceiver operation varies depending on the configuration of the Trunking Type
("Transmission Trunked" or "Message Trunked (Enhanced)"). (Refer to
Trunking Type
For an Individual Call and Group Call in an NXDN Trunking system, the method for releasing a traffic channel varies as
follows, depending on the configuration of the Trunking Type. The configuration for Trunking Type must be changed along
with the configuration of the system.
Configuration
The system releases a traffic channel after the communication ends on the traffic channel by a user of the
transmitting transceiver releasing the PTT switch.
Transmission This parameter can be used for traditional type calls such as an Individual Call and Group Call which do not
Trunked determine whether or not the receiving transceiver is available for communications before initiating a call.
(Refer to
(Transmission Trunked) on page
The link to a traffic channel is maintained after the communication ends by a user of the transmitting transceiver
releasing the PTT switch on a traffic channel until a certain period of time elapses. To release the traffic channel
before a certain period of time elapses, an additional operation is required on the transceiver. While the link to a
traffic channel is being maintained, the transceiver can communicate again without reestablishing a link by
Message Trunked pressing the PTT switch.
(Enhanced) This parameter can be used for calls such as an Individual Call and Group Call which determine whether or not
the receiving transceiver is available for communications before initiating a call. (Refer to
Individual Call After Ensuring That the Target Party Is Available for Communications (Message Trunked
(Enhanced)) on page
Trunked (Enhanced)) on page
Note
In multiple systems, Trunking Type can be configured for each system.
Configuration using KPG-111D/ DN
• Configuring the Trunking Type (Single System) (
• Configuring the Trunking Type (Multiple Systems) (
FUNC (K)/Ver 4.00
Table 9-4 Trunking Type
9.5 Making an Individual Call (Transmission Trunked) on page
220.)
214, 9.8 Making a Group Call with the Link to a Traffic Channel Retained (Message
225.)
See
Trunking Type on this
Description
FPRG 8.19.4 Trunking Tab)
See FPRG 8.20.3 General Tab)
page.)
204, 9.7 Making a Group Call
9.6 Initiating an
CONTENTS INDEX 203