Kenwood NEXEDGE NX-200 Function Reference page 246

9 NXDN TRUNKING SYSTEM
9.5 Making an Individual Call (Transmission Trunked)
Notifying the User with a Tone That a Call Request Has Been Initiated (Call Request Tone)/
Notifying the User with a Tone That a Call Request Is in Progress (Call Processing Tone)
Call Request Tone is the function to sound a Call Request Tone from the transceiver when a call request for an Individual
Call or Group Call is initiated by pressing the PTT switch in an NXDN Trunking system.
Also, Call Processing Tone is the function to sound a Call Processing Tone from the transceiver while the PTT switch is
pressed and held after a call request for an Individual Call or Group Call is initiated by pressing the PTT switch in an NXDN
Trunking system.
Depending on the system condition, it may take few seconds to determine the call request upon the initiation of a call
request using Individual Call or Group Call. Use of this function notifies a user by emitting a tone from the transceiver of the
condition from when the transceiver initiates a call request using Individual Call or Group Call until the call request is
determined.
When the transceiver initiates an Individual Call or Group Call using this function, the transceiver behaves as follows.
A: Initiating a call request
A Call Request Tone sounds
from the transceiver.
Call Processing
Tone Delay Time
0
A: A Call Request Tone sounds from the transceiver when a call request has been initiated by pressing the PTT switch.
B: A Call Processing Tone sounds from the transceiver while the PTT switch is pressed and held after initiating a call
request by pressing the PTT switch. The length of time from when a call request is initiated by pressing the PTT switch
until the Call Processing Tone sounds from the transceiver can be configured for Call Processing Tone Delay Time.
C: If PTT Proceed Tone is enabled, a PTT Proceed Tone sounds from the transceiver when a call request is determined.
A user can start conversations. (Refer to
Tone) on page 92.)
Note
This function can be used with the following calls.
• Individual Call (Message Trunked (Enhanced))
• Group Call (Transmission Trunked)
• Group Call (Message Trunked (Enhanced))
Configuration using KPG-111D/ DN
• Configuring the Call Request Tone to be enabled or disabled (
• Configuring the Call Processing Tone to be enabled or disabled (
FUNC (K)/Ver 4.00
B: Processing the call request
A Call Processing Tone sounds
from the transceiver.
1 2 3 4
Figure 9-5 Call Request Tone/ Call Processing Tone
Using Sound to Notify the Timing to Start Communications (PTT Proceed
C: Determining the call request
A PTT Proceed Tone sounds
from the transceiver.
5
See FPRG 8.19.4 Trunking Tab)
See FPRG 8.19.4 Trunking Tab)
CONTENTS
Time [sec]
INDEX 212