Kenwood NEXEDGE NX-200 Function Reference page 253

9 NXDN TRUNKING SYSTEM
9.6 Initiating an Individual Call After Ensuring That the Target Party Is Available for Communications (Message Trunked (Enhanced))
 If Automatic Response is enabled:
1
Receive from the system a message requesting reception of an Individual Call.
A message requesting the connection is automatically sent to the
system.
2
Receive from the system a message for traffic channel assignment.
An Alert Tone (Individual Call) sounds from the transceiver, the ID
of the transmitting transceiver appears on the main display, and
the transceiver becomes enabled for communications.
Note
• The DTMF code can be sent during the call by pressing one of the [0] key to [9] key, the [*] key or the [#] key while pressing and
holding the PTT switch.
• The Individual Call ends by pressing the Side 1 key, (Portable), the Triangle key (Mobile) or the [#] key. For Mobile, if the Mic On-hook
Disconnect is enabled, an Individual Call terminates by placing the microphone in the on-hook state.
• If the transceiver receives an Emergency Call, the transceiver automatically sends a message requesting a connection regardless of
the configuration for the Automatic Response.
• By pressing the PTT switch, the transmitting transceiver can be called.
• If the received Unit ID is configured in the Unit ID List, an Alert Tone sounds from the transceiver according to the configuration for Alert
Tone (Individual) of the corresponding Unit ID. If the received Unit ID is not registered in the Unit ID List, the Alert Tone sounds from the
transceiver according to the configuration for Alert Tone (Individual) which is commonly used.
Configuration using KPG-111D/ DN
• Configuring the Alert Tone (Individual Call) (Unit ID List) (
• Configuring the Alert Tone (Paging Call) (Unit ID List) (
• Configuring the Alert Tone (Individual Call) which is commonly used (
• Configuring the Alert Tone (Paging Call) which is commonly used (
FUNC (K)/Ver 4.00
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
See FPRG 8.19.6 Unit ID List Tab)
See FPRG 8.19.6 Unit ID List Tab)
FPRG 8.19.4 Trunking Tab)
See
FPRG 8.19.4 Trunking Tab)
See
CONTENTS
Mobile
Mobile
INDEX 219